Bell satellite TV is snow

notaclue — Mon, 16 Dec 2024 15:42:07 GMT

TV screen is snow

How to return to channels

Re: Bell satellite

WelshTerrier — Sat, 14 Dec 2024 17:48:56 GMT

Good Day & Welcome to the Bell Community Forum

Have you made recent changes to your TV settings? Have you checked out that the cables are seated properly on the receiver & TV?

Your TV may not be on the right input setting if you see the following on your TV screen:

Blue screen
Snowy screen
Black screen
"No signal" message

To change the input of your TV:

Note: If you have access to the back of your TV, you can check where the cable that’s coming from the Bell TV receiver is inserted to determine what the input is called.

Make sure your TV and your satellite TV receiver are turned on (a green or blue light will be lit on the front panel of the receiver).
Using your TV’s original remote control, press the INPUT or SOURCE key repeatedly, pausing two seconds between presses, to cycle through all the inputs of your TV.
Note: Some TV manufacturers call the key TV/VIDEO or MODE.
Stop pressing the INPUT key when the picture comes back.
If cycling through the inputs does not restore the picture, try tuning your TV to channel 3, 4, 60 and then 73.
Note: This step only works if your TV is connected to the satellite TV receiver with a coaxial cable.

If you are still getting a blue or snowy screen after trying to change the inputs and the channels, please contact Bell Satellite TV Tech Support at: 1 888 759-3474

Let us know if you require further assistance.

Take care.

topic Bell satellite TV is snow in TV & Streaming

Bell satellite TV is snow

Re: Bell satellite