I just went through setting up PPoE for my Linksys Velop system functionality, which hasn't improved performance noticeably but now the IPTV is not working. Any help is appreciated.
Hi Tim, I have this exact set up and tried using the Giga hub in ADMZ and the router in PPPoE mode allowing the Velop to establish the IP, but it is no good. I finally figured out that setting the Velop to bridge mode only and using the Giga hub to e...
Yes that's correct. Thanks I'll try and putting the VLAN identifier and see if that works. There's no VLAN number currently in use for the pppoe. I tried to sort that out with Bell Technical and they couldn't decide if it was needed. It seems to have...
My current setup is functioning utilizing the pppoe bypass and the advanced DMZ config on the modem. Unfortunately the IPTV is not functioning. I'm not sure what to change in either the router settings or the modem settings to allow the IPTV to pass ...
If Bell has made the decision to design their system so that it is only compatible with their own pod system, that's absolutely fine. However, Bell needs to admit that openly so customers can make properly informed decisions about whether to use th...
