ADMZ issues again? Packet loss and disconnects

Wyatt15
Contributor

Just starting a new thread to raise a problem that is resurfacing. Just over a two weeks ago I started experiencing frequent packet loss every 10min where the end device would still be connected to the network but the application would drop altogether. I have been running a ucg (non fiber) for over a year and a half in the ADMZ configuration to get the full use of my 3gig service. This setup had been working fine for over a year and a half but all of a sudden around October 5th I started noticing connection issues random drops here an there on the application side with no change the network itself. This got worse with packet loss spiking up to 15-18% evey 5-10min. I did the obvious and rebooted the whole network but there was no change. So I factory reset the gigahub and reapplied the configuration but no change as I was still getting high packet loss. So thinking the device was fault I got a replacement but alas the issue still remained. However if I did the PPPoE connection option from the ucg to the gigahub the issue goes away (found this out after the replacement was already on its way). This leads me to believe bell pushed a bad firmware again causing the ADMZ configuration to break, wether it's a nat routing issue or bad DHCP provided leases I'm not sure. but this seems to be the likely culprit since the issue was experienced across multiple gigahubs and only started earlier this month. Has anyone else been experiencing this on their setup?

The unfortunate part is that now with the PPPoE configuration I'm down a solid 1 gig on my connection now 😞 

0 0 92
0 REPLIES 0