Connect VIP2262 receiver to Wi-Fi

Fuzion-77
Contributor

Can an HDR TV receiver VIP2262 connect to a Giga hub via wifi?

0 4 3,116
1 helpful reply

Accepted Solutions

WelshTerrier
Community All-Star
Community All-Star

Good Day & Welcome to the Bell Community Forum.

The HDPVR TV receiver VIP2262 can connect to a Giga Hub by ethernet cable. The VIP2262 does not support a Wi-Fi Connection.

Take care.

I am a Community All-Star and customer. I'm here to help by sharing my knowledge and experience. My views on Bell and the Community Forum are my own and not the views of Bell or any of its affiliates.

View reply in original post

4 REPLIES 4

WelshTerrier
Community All-Star
Community All-Star

Good Day & Welcome to the Bell Community Forum.

The HDPVR TV receiver VIP2262 can connect to a Giga Hub by ethernet cable. The VIP2262 does not support a Wi-Fi Connection.

Take care.

I am a Community All-Star and customer. I'm here to help by sharing my knowledge and experience. My views on Bell and the Community Forum are my own and not the views of Bell or any of its affiliates.

Apparently, that doesn't always work.

I've spent a frustrating week trying to do just that. We just got a new Giga Hub, a replacement for a Home Hub 4000 whose wifi had failed. The wifi on the new Giga Hub works fine - our computers and tablets can all connect to it. However, our Bell Receiver, also a 4K VIP5662 model, won't pair with the modem. After hours on the phone with several support techs, they finally sent out a new VIP5662 receiver, and I've gone through the pairing procedure several times (selecting "Connect a Fibe Receiver" on the modem, then Select on the TV remote). The new receiver behaves exactly like the old one (Error 262 W); the replacement receiver  also refuses to connect over wifi.

Since we still have Powerline Ethernet set up in our home, it occurred to me that the problem was not anything to do with the receiver, but a broken pairing procedure. I set up a wired connection to the receiver, and sure enough, it's working just fine now.

That might be a good troubleshooting tip to suggest to customers, if they happen to have a wired ethernet option available. 

Sorry, my mistake - my model is actually a  VIP5662. It has an ethernet port but a Bell tech says it's just for service. (It does actually work for TV, but terribly, continually dropping the signal.

Good Day & Welcome.

Thank you @jamesepatterson for contacting the Bell Community Forum.

The HDPVR TV receiver VIP5662w can connect to a Giga Hub by ethernet cable.

  • Turn off your TV and unplug your VIP5662w from its power source.
  • Plug one end of the ethernet cable into the back of your modem and the other end of the cable directly into VIP5662w.
  • Plug your receiver back in and turn your TV back on. Your receiver will now connect to the Bell network. This process can take 5-10 minutes to complete.
  • You can use any spare Ethernet port on your modem to hardwire a connection directly to your TV receiver.
  • You cannot extend both data and TV over a switched network using the same Ethernet port on your modem.
  • If you plan on hardwiring your Bell receivers, each receiver must be connected directly to the Giga Hub modem. The wiring for each, must run directly to the Bell Giga Hub modem. Each connection must be point to point to the Bell modem. 

Let us know if you experience any further issues.

Take care.

I am a Community All-Star and customer. I'm here to help by sharing my knowledge and experience. My views on Bell and the Community Forum are my own and not the views of Bell or any of its affiliates.