Receiver 9242 HDMI + remote

[lanopie]

On a 9242, is it possible to switch the HDMI part of the receiver (1) to be controlled by a UHF remote instead of the IR remote?

My problem is my receiver is in the basement and my TV is on the first floor.  With a 9241 receiver, the HDMI is controlled by a UHF remote.

The UHF remote controls the TV2 part of the receiver I would like to reverse it.  Is it possible?

Thanks!

[WelshTerrier · Accepted solution]

Good Day.

It is not possible to make this change. It is pre-configure by the manufacturer to operate this way.

Take care.

[lanopie]

Thanks for the reply.  I did notice that if you change the Mode to a single receiver, that works.  In my case I don't need to control the second receiver.

[WelshTerrier · Accepted solution]

Thank you for sharing this with us.

That will work correct as long as you have only one receiver. 

https://support.bell.ca/tv/receivers/what_are_the_single_and_dual_modes_on_my_bell_satellite_tv_rece...?

Take care.