Home Hub 2000 Management

Go to helpful replies
Nitpick
Contributor

‎12-27-2023 01:10 PM

My Home Hub 2000 reports:

Hardware version:  5250-000004-001

Firmware version:  SG9815205C

User Interface:  6.2.1

Is there any update for the firmware?  If there is how do I get it and how do I install it?

Is there any update for the user interface?  The documentation suggests that there is the ability to set the brightness of the display lights to high or low, but I can find no place to do this.  Is there a way, and if so where?  Also on the MAC filtering page, the area where a MAC address can be entered manually overlays the display of MAC addresses (the left hand column) so that not all of them are visible or reachable.  Is there a way to get around this?  

0 Likes
0 1 1,308
1 helpful reply

Accepted Solutions

Go to helpful replies
Vanadiel
Community All-Star
Community All-Star

‎12-27-2023 02:49 PM

Firmware updates are pushed automatically when the modem is connected to the network.

Not sure what the latest firmware revision is for the 2000, but if an update is needed it will update itself.

 

Most tutorials these days are pretty basic. Home Hub 2000 Tutorials 

I am a Community All-Star and customer. I'm here to help by sharing my knowledge and experience. My views on Bell and the Community Forum are my own and not the views of Bell or any of its affiliates.

View reply in original post

1 REPLY 1

Go to helpful replies
Vanadiel
Community All-Star
Community All-Star

‎12-27-2023 02:49 PM

Firmware updates are pushed automatically when the modem is connected to the network.

Not sure what the latest firmware revision is for the 2000, but if an update is needed it will update itself.

 

Most tutorials these days are pretty basic. Home Hub 2000 Tutorials 

I am a Community All-Star and customer. I'm here to help by sharing my knowledge and experience. My views on Bell and the Community Forum are my own and not the views of Bell or any of its affiliates.