Connecting Bell fibre directly to UDM SE with SFP+ and PPPoE

Go to helpful replies
DMot
Contributor III

‎01-17-2023 11:19 PM - last edited on ‎11-08-2024 02:36 PM by

Has anyone connected directly to their router with an SFP and PPPoE or another method?  I'm looking for the right 10Gig SFP, but I'm not sure what one to get

I have a Ubiquitiy UDM SE gateway/router.  Currently I have a 10 Gig SFP+ to RG45 with a patch between it and the HH4K's 10G RJ45 port.  I'd like to eliminate the HH4K and go direct if possible.

thanks.

0 Likes
0 150 66.9K
150 REPLIES 150

Go to helpful replies
yokushka
Contributor II

‎12-09-2025 10:10 PM - last edited on ‎12-10-2025 09:36 AM by

It seems that each piece of equipment behaves differently (HH4000, FW:2.14, Location: QC )

  • ER-4 - Experiences packet loss with DHCP and double NAT, but works fine with ADMZ. However, after a modem reboot, I need to reset ADMZ; otherwise, packet loss occurs.
  • UCG-Fiber - Works reliably with DHCP and double NAT. ADMZ also functions correctly, but only when PPPoE is configured. No VLAN settings are required.
  • HH3000 (used) - I extracted ONT from it, but I haven’t been able to get it working at all. At this point, I suspect the unit may simply be defective.

    Update: Solution could be It looks like ONT needs to be activated for account.